Sunday, March 4, 2012

How to sew the chenille strips on (tutorial part 2)

In my last post you got to the part where you had your chenille strips ready to go. In this  post I will demonstrate how to sew them on the flower petals in my case, but they could be outline to anything you desire.
So for this demo I started with a 4" inch square and I fused a flower petal on it. Of course you have  your own fused flower, etc. that you will start with.


Next you'll need to  pin the chenille strip on the edges in a way that the stitches in the center of the chenille strip should line up about 1/16" from the edge of the petal like this:
How to make chenille strips


Make sure you stay consistent in the curves and don't make the strip too tight.


After pinning it should look like this:
Note that I used the pins a lot more frequently in the curves.

Don't  panic because your work will not be flat.


Start sewing the strip on following the sewing line in the middle. Take your time! When you get to the curve only take 2-3 stitches then stop and remove the next pin. If you have needle down position on your sewing machine now is the time to use it.


When you're done sewing you'll  be at  this stage:


Again,  your strips will not lie flat, but it's OK!

Normally after this step you'll piece your blocks together, sandwich, baste and quilt your quilt, then put the binding on. After all is finished it's time to throw it in the wash. When it comes out nice and clean, you'll need to dry it until the whole quilt is dried completely. With my demo I skipped these steps since I didn't want to make another quilt :) Caution: do  not start to brush the strips until the whole quilt is stabilized. If you don't want to wash and dry it, that's fine! It just makes the brushing easier because it loosens the fibers up (Is that the right term?)

The next to last thing you'll need to do is spray it with a little water. A little  mist is fine, it doesn't have to be soaking wet.


Now last, but not least, brush away!


It will be nice and fluffy when you're finished! I obviously did not have the  patience to finish, but you get the picture!


Your brush will have lint all  over so you'll need to clean it very frequently.


 I collected the lint pieces in this container.  It was full by the time I finished brushing all the flowers on my quilt.


Note to people with dust allergies: You  might want to wear a mask of some type. I don't have any allergies, but I looked like I had a cold by the time I  was finished.

Let me introduce my 2 helpers (NOT!) who were in my way the whole time. By the end they were so tired of helping me they needed to take a nap!

Kormi


Szundi

Hope you enjoyed this tutorial as much as they did!

11 comments:

  1. Thanks, Kati. I had not considered using that many strips of fabric. I may try this on a baby quilt soon.

    Your first tutorial is a success!

    ReplyDelete
    Replies
    1. You don't have to use that many strips, it depends how many flowers you want to put on your quilt. For the ones that are on mine I needed 2 12" squares and I have more than half of it left for the next project. Thank you for your kind words! If you try it post a picture, I'd like to see!

      Delete
  2. SO cute! I can't wait to try this! what type of brush is that? I love the cats :) they would love all of that fluff!

    ReplyDelete
    Replies
    1. It's a special chenille brush, you can get it here:
      http://www.nancysnotions.com/product/chenille+brush.do
      I googled it and this was the first result I got, you can look around if you can get it any cheaper somewhere else.

      Delete
  3. Thanks so much for the tutorial! Such a neat effect used this way thanks.

    ReplyDelete
  4. These are awesome, thank you! So ridiculous to spend so much money on the pre-sewn by the inch stuff when you can make your own in any colors you choose! I just KNEW there had to be a way to do it and I'm so glad I found yours!

    ReplyDelete
  5. This is awesome, thank you! It's so ridiculous to spend so much $ buying the by-the-inch stuff when you can make your own in any colors you choose. I just KNEW there had to be a way! I'm so glad I found yours! (Pinned it on Pinterest here: http://pinterest.com/pin/157626055680123652/ and here: http://pinterest.com/pin/426364289692755956/ )

    ReplyDelete
  6. Interesting technique but what is the purpose of using the water misting? What does that do for it? Thanks

    ReplyDelete
    Replies
    1. The misting loosens up the fibers and it's easier to brush, and also it fluffs more easily.

      Delete

I am truly glad you visited, and a special thanks to You for taking your time to leave a comment! It always makes me smile when people write to me. Thanks, from the bottom of my heart! :)